UMM 1/72 PropMaster
By Matt Bittner
UMM's latest tool for the modeler is one that will help with adding propellor blades to hubs and spinners. There are a number of spacers that are used to acheive the correct depth for the blades, which are screwed into the center. Once that is set, then you put the spinner/hub into the center and start gluing on the blades.
This tool allows one to add two- three- and four-bladed props, along with either left- or right-hand pitch. That is achieved based on which side of the PropMaster you use. One side is for right-handed pitch, turn it over and that side is for left-handed pitch.
The tool is made out of very strong steel so there's no worry about the tool slipping while your adding your prop blades. It's very heavy and feels good in the hand.
If you're looking for a tool to help you align propellor blades, then look no further than the PropMaster.
My thanks to UMM USA for the review PropMaster.